Slope by Cut Depth

Description

This component varies the slope based on depth of cut. Three heights are entered defining 4 possible slopes:

  

Parameters

CutHeight1 Lowest cut height. Cuts less than this height have CutSlope1.
CutHeight2 Middle cut height for widening. Should be greater or equal to CutHeight1. Cuts less than this height have CutSlope2.
CutHeight3 Highest Cut height for widening. Should be greater or equal to CutHeight2. Cuts less than this height have CutSlope3.
CutSlope1 Cut slope when height is less than CutHeight1.
CutSlope2 Cut slope when height is greater than CutHeight1 and less than CutHeight2.
CutSlope3 Cut slope when height is greater than CutHeight2 and less than CutHeight3.
CutSlope4 Cut slope when height is greater than CutHeight3.
CutSlope Cut Slope applied if component attachment point is in cut.

For more information contact us at mail@softree.com.

Return to the Softree Homepage