BAUD RATE:9600
PARITY:Even
DATA BITS:7
STOP BITS:1
FLOW:H/W
SWITCHES
| Sw | 1 | 2 | 3 | 4 | 5 | 6 | 7 | 8 | 9 | 10 | 11 | 12 | 13 | 14 | 15 | 16 | 17 | 18 |
| A B |
0 0 |
1 0 |
0 1 |
0 0 |
0 0 |
1 1 |
1 0 |
1 0 |
0 0 |
0 0 |
1 0 |
0 0 |
0 0 |
0 0 |
0 0 |
0 0 |
0 0 |
0 1 |
COMMENTS
Restore Factory Setting (Restore 3). This setting will configure the tablet to CalComp 2000 ASCII format. Set to Point Mode.
To setup to run in track mode set
A-1 to on
A-2 to off
This driver can be used for the Drawing Board III. - Preset digitizer to #3 config - Set BANK A: Key #1 on - Set BANK A: Key #2 off
For Drawing Board III set A-17 on (include LF).
| Key
0 1 2 3 4 9 A B D E |
Function
SAME UP DOWN UNDEF UNDO END ATTRIB NEGATIVE DECIMAL ENTER |