The dialog allows you to set the properties of a feature. It is accessed from either the Edit - New Feature menu or the Edit - Modify Selected Features - Properties menu.
Enter the feature name or select a layer name from the list. If another feature exists with the same name, a unique sub-ID is automatically determined.
Check this option if feature is to be displayed.
Check this option if feature is connected.
Check this option if the feature has elevations.
Check this option to include the feature in the TIN model. If the feature does not have elevations, it will become a draped feature.
This item will only be available if the feature has elevations and modelled is checked. Check this option if the feature is a breakline.
Check this option to set the Area Property for the feature. If a feature is negative its area will be subtracted when total areas are reported.
Check this option to use the feature to limit the TIN. The feature should be a polygon. Triangles with their centerpoint outside this polygon will be excluded from the TIN.
Check this option to use the feature to delineate an area within which surface area and average slope will be calculated. Also used to limit volume calculations. Volumes inside this boundary will be reported separately.
This section will be available only when this dialog is accessed from the Edit - New Feature menu.
This button will activate the Edit Points mode, allowing you to create new features or edit existing features with the mouse.
This button will popup the Feature Coordinates Dialog, allowing you to type in coordinates of a new feature.
This button will allow you to draw a new feature using a digitizer.